Hypertherm 123492 Cable
Part Description
This is a cable for the Hypertherm HD4070 plasma cutter. It runs from the breakout board to the THC communications board.
Specifications
- Length: 6 feet
- Gauge: 18 AWG
- Material: PVC
Compatibility
This cable is compatible with the following Hypertherm plasma cutters:
- HD4070
Installation
To install this cable, follow these steps:
- Disconnect the power from the plasma cutter.
- Remove the side panel of the plasma cutter.
- Locate the breakout board and the THC communications board.
- Connect the cable to the breakout board and the THC communications board.
- Replace the side panel of the plasma cutter.
- Restore power to the plasma cutter.
Troubleshooting
If you are experiencing problems with this cable, check the following:
- Ensure that the cable is properly connected to the breakout board and the THC communications board.
- Check the cable for damage.
- If the cable is damaged, replace it with a new one
Similar Parts
041613
PCB6 Breakout Board
123548
Cable: HD4070 THC Noz 75 ft.
123419
CABLE:HPR/HD4070 Ignition Console Power Cable, 10 ft
041616
Plasma Interface Board for HD4070 Power Source
041625
PC Board Assembly for HD4070
041664
PC104 Board for HD4070 Power Source NEW PART # 141023
141023
PC104 Board for HD4070 Power Source
041706
Command THC Control Board upgraded board ** MUST ORDER KIT#128407
123512
Cable, Gas console to PS, 50 ft., HT4400/HD4070 plasma system
128892
HPR / HD4070 torch leads - 15 feet