Hypertherm 003153 Main Contactor for Max-100

Product Description

The Hypertherm 003153 Main Contactor for Max-100 is a genuine replacement part for Hypertherm Max-100 plasma cutters. This contactor is responsible for controlling the flow of power to the plasma torch. It is a critical component of the plasma cutter and should be replaced if it becomes damaged or worn out.

Specifications

• Brand: Hypertherm
• Part Number: 003153
• Part Description: Main Contactor for Max-100
• Voltage: 240V
• Current: 40A
• Duty Cycle: 60%
• Ambient Temperature: -20°C to +50°C (-4°F to +122°F)
• Storage Temperature: -40°C to +70°C (-40°F to +158°F)
• Weight: 0.5 lbs (0.23 kg)

Installation

The Hypertherm 003153 Main Contactor for Max-100 is a direct replacement for the original contactor. It can be installed by following these steps:

1. Disconnect the power supply to the plasma cutter.
2. Remove the side panel of the plasma cutter.
3. Locate the old contactor and remove the two screws that hold it in place.
4. Remove the old contactor.
5. Install the new contactor by reversing the removal steps.
6. Reconnect the power supply to the plasma cutter.

Troubleshooting

If the plasma cutter is not working properly, the contactor may be the cause. Here are some troubleshooting tips:

• Check the contactor for signs of damage, such as cracks or burns.
• Check the contactor connections to make sure they are tight.
• Test the contactor with a multimeter to make sure it is working properly.
• If the contactor is damaged or not working properly, replace it with a new one.

Conclusion

The Hypertherm 003153 Main Contactor for Max-100 is a critical component of the plasma cutter. It is responsible for controlling the flow of power to the plasma torch. If the contactor becomes damaged or worn out, it should be replaced to ensure the plasma cutter is operating properly.